I'm trying to get my Sansa&nbsp; e260 to work under Gentoo.<br><br>I can mount the flash via /dev/sda1, but I can't find the microSD card under linux.<br>I expected it would show up as /dev/sdb or something like that, but no dice.
<br><br>
lsusb gives me:<br><div style="margin-left: 40px;">Bus 001 Device 014: ID 0781:7421 SanDisk Corp.<br></div><br>When it's plugged in, this is what dmesg reports:<br><div style="margin-left: 40px;">usb-storage: device found at 14
<br>usb-storage: waiting for device to settle before scanning<br>&nbsp; Vendor: SanDisk&nbsp;&nbsp; Model: Sansa e260&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; Rev:<br>&nbsp; Type:&nbsp;&nbsp; Direct-Access&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; ANSI SCSI revision: 00<br>SCSI device sda: 7854080 512-byte hdwr sectors (4021 MB)
<br>sda: Write Protect is off<br>sda: Mode Sense: 45 00 00 00<br>sda: assuming drive cache: write through<br>SCSI device sda: 7854080 512-byte hdwr sectors (4021 MB)<br>sda: Write Protect is off<br>sda: Mode Sense: 45 00 00 00
<br>sda: assuming drive cache: write through<br>&nbsp;sda: sda1 sda2<br>sd 2:0:0:0: Attached scsi removable disk sda<br>usb-storage: device scan complete<br></div><br>Syslog reports basically the same information with this additional line:
<br><div style="margin-left: 40px;">[scsi.agent] disk at /devices/pci0000:00/0000:00:11.2/usb1/1-2/1-2:128.0/host2/target2:0:0/2:0:0:0<br></div><br>The only nodes udev creates is sda, sda1, and sda2. The sda1 is the accessible built-in flash and sda2 is the firmware image. Am I missing a kernel module?
<br><br>Any ideas? Even if it's just a pointer to a better place to ask this question<br><br>dcm<br>.<br>