On 10/16/11 11:29, Matthew Finkel wrote:
> On Sun, Oct 16, 2011 at 11:05 AM, CJoeB <colleen.beamer@gmail.com
> <mailto:colleen.beamer@gmail.com>> wrote:
>
>     > Also: Are the modules actually loaded before you unload them? Use
>     > `modprobe -vr broadcom tg3`. If there is no output, the module
>     was not
>     > loaded.
>     Prior to unloading the modules, output from 'modprobe -vr broadcom
>     tg3' is
>
>     rmmod /lib/modules/2.6.39-gentoo-r3/kernel/drivers/net/tg3.ko
>
>
> Hi Colleen,
>
> Looks like broadcom isn't loading at boot. Also, I'm not too familiar
> with broadcom, but why must you load two modules? I found [1] which
> sound like your problem (possibly the site you mentioned earlier)
> which references a similar problem when tg3 is loaded before broadcom.
> You may have already tried this, but have you tested changing the
> order in /etc/conf.d/modules?
>
>
> [1] https://bbs.archlinux.org/viewtopic.php?id=110026
>
> - Matt
>
> -- 
> Matthew Finkel
Tried changing the order of module loading.  Didn't change anything! 
:-(  But this was a good idea that I never thought of!

Colleen.

-- 

Registered Linux User #411143 with the Linux Counter, http://counter.li.org