Re: [gentoo-user] Boot hangs after install, no error

[Jake Moe <jakesaddress@gmail.com>]

On 18/06/10 14:05, Albert Hopkins wrote:
> On Fri, 2010-06-18 at 13:54 +1000, Jake Moe wrote:
>   
>> I had tried to see if there was anything special about the hardware,
>> but
>> couldn't find anything.  I'm still of the opinion that it's something
>> to
>> do with the kernel, but I've given up on amd64 (I'm not sure if I've
>> had
>> an amd64 Gentoo PC before) and switched back to x86, and other than
>> forgetting SCSI disk support in the kernel for my SATA disk (which I
>> *always* do, why can't they make SCSI disk support a requirement for
>> SATA AHCI support?), the install went smoothly.  The only other thing
>> of
>> note is that I seem to need to use the unstable ndivia-drivers
>> (195.36.24), as the latest stable one (190.42-r3) produced flickering
>> garbage on my screen when I went into X.
>>
>> Thanks for trying to those that did.
>>
>> Jake Moe 
>>     
> Did you compile your own kernel or use genkernel?  Did you try using the
> same kernel config as the live cd (assuming that the livecd boots fine)?
>
> -a
>   
No, I was tempted to try genkernel, but again, OCD got the best of me; I
like Gentoo because I tell it what I want and need, and it does that and
nothing else.  Genkernel, in my understand, does everything (and
apparently does it pretty well), but it means that it's bigger than it
needs to be.  Plus, I hadn't gotten a reply back in a while, and I'm
limited on time with this laptop, so I went back to that which I know
better.

And I thought the Live CD used genkernel; I thought that was where
genkernel came from in the first place?  Is it different?

Jake Moe