Am Tue, 22 Dec 2015 00:50:24 +0000
schrieb Mick <michaelkintzios@gmail.com>:

> > You could try running the service in debug mode (--debug), and look
> > at the line starting ifplugd. Check if the parameters look correct,
> > then try to fire the same command from command line and check the
> > console output for errors.  
> 
> ifplugd does not have a debug mode, but starting it by hand I see
> this:
> 
> Dec 22 00:38:08 dell_xps ifplugd(eth0)[4982]: ifplugd 0.28
> initializing. Dec 22 00:38:08 dell_xps ifplugd(eth0)[4982]: Using
> interface eth0 Dec 22 00:38:08 dell_xps ifplugd(eth0)[4982]: Failed
> to detect plug status of eth0
> Dec 22 00:38:08 dell_xps ifplugd(eth0)[4982]: Exiting.
> 
> Ha!  It now assumes that I have an eth0 interface, which I don't.
> Hmm ...  I wonder where it reads this from.

man ifplugd ;-)

-- 
Regards,
Kai

Replies to list-only preferred.