Re: [gentoo-user] troubles with ati-drivers-8.25.18

[Mauro Arnoldi <agharti81@tiscali.it>]

Alle 17:28, martedì 13 giugno 2006, Jacques Montier ha scritto:
> Mauro Arnoldi a gentiment tapote:
> > Alle 15:22, martedì 13 giugno 2006, Jacques Montier ha scritto:
> >> Mauro Arnoldi a gentiment tapote:
> >>> Alle 14:31, martedì 13 giugno 2006, Ptitjack ha scritto:
> >>>> Mauro Arnoldi a gentiment tapote:
> >>>>> Hello!
> >>>>>
> >>>>> I installed a new Gentoo system, but I find big problems with ati
> >>>>> drivers and 3D acceleration. I have followed the wiki howto but now I
> >>>>> receive this error message
> >>>>>
> >>>>> #fglrxinfo
> >>>>> Xlib:  extension "XFree86-DRI" missing on display ":0.0".
> >>>>> display: :0.0  screen: 0
> >>>>> OpenGL vendor string: Mesa project: www.mesa3d.org
> >>>>> OpenGL renderer string: Mesa GLX Indirect
> >>>>> OpenGL version string: 1.2 (1.5 Mesa 6.5)
> >>>>>
> >>>>> I saw the Troubleshooting:
> >>>>> If fglrxinfo says "mesa3d.org" instead of "ATI" after A SUCCESSFUL
> >>>>> modprobe of fglrx, but nothing changes.
> >>>>> I include my configuration, hoping that someone can help me out of
> >>>>> this mess...
> >>>>>
> >>>>> kernel version: 2.6.16-gentoo-r9
> >>>>> in "Character Devices":
> >>>>> 	/dev/agpgart (AGP Support) 	M
> >>>>> 	ATI chipset support			M
> >>>>
> >>>> Hi,
> >>>>
> >>>> I think  you have to disable ATI chipset support in Character Devices
> >>>> (/dev/agpgart must be enabled as module).
> >>>> I Hope it will help.
> >>>
> >>> Nothing changed:
> >>
> >> After you have changed your kernel configuration, I suppose you
> >> recompiled your kernel ?
> >> Did you enable via chipset support in Character Devices ( then modprobe
> >> via-agp) ?
> >> After compiling ati-drivers, did you run
> >> eselect opengl set ati ?
> >
> > eselect is ok:
> >
> > #eselect opengl list
> > Available OpenGL implementations:
> >   [1]   ati *
> >   [2]   xorg-x11
> >
> > Why do I have to compile via chipset support? I have and Ati Radeon X300
> > in my laptop..
>
> because of my VIA KT133A chipset motherboard.
> Without loading via-agp module, I don't have any 3D acceleration.
> What gives lspci  | grep AGP ?

I find nothing!! :-O
But maybe the correct line is 

00:01.0 PCI bridge: Intel Corporation Mobile 915GM/PM Express PCI Express Root 
Port (rev 03) (prog-if 00 [Normal decode])

because a radeon X300 it's not an AGP card but a PCI Express...
I enabled in my kernel the "Intel 440LX/BX/GX, I8xx and E7x05 chipset 
support", but still nothing at all... I always receive the error above...
I'm getting crazy.. 

-- 
gentoo-user@gentoo.org mailing list