Thanks a lot, I´ll try soon I have time, now I´m going to a business 
trip , so I´ll spend 2 week outside my home, then as soon I be back I 
will look for my real solution.
Thanks a lot again, my Windows Vista is Working  and it is enought to 
work mean while <i finish my gentoo installation.
Regards
Sigfrido


bss03@volumehost.net wrote:

>On Sunday 18 February 2007 20:31, sigfrido V. Ortiz C. wrote:
>  
>
>>I did, but something is wrong, I´ll comment soon.
>>I can start with Windows Vista [32 bit edition], editing GRUB comand, it
>>is because I wrote in my grub.conf  (sda0.x) and changuing it to
>>(hda0,x) the Windows vista run fine.
>>    
>>
>
>Yeah, grub never uses sd* names, always hd* and always in the order 
>presented 
>by BIOS (as opposed to Linux, which presents them as they are discovered 
>through device probing with names dependent on the module/subsystem).
>
>  
>
>>Gento can not run yet, nut as soon a have more time I will try it again.
>>    
>>
>
>You can probably use grub TAB-completion to determine the correct (hd*) 
>setting.  Generally, your boot partition will have a vmlinux or vmlinuz 
>file 
>on it. So, the workflow would go something like:
>
>GRUB> (hd<TAB>
>0 1
>GRUB> (hd0,<TAB>
>0 1 2 3
>GRUB> (hd0,0)/vm<TAB>
>GRUB> (hd0,1)/vm<TAB>
>GRUB> (hd0,2)/vm<TAB>
>vmlinuz vmlinuz.old vmlinuz-gentoo-2.6.19-r2 vmlinuz-gentoo-2.6.18-r6
>
>At this point you know your /boot partition is (hd0,2) in grub-speak.
>
>If don't have a dedicated /boot partition, and instead it's part of the / 
>filesystem you'll want to look for boot/vmlinux or boot/vmlinuz instead.  
>This may work even if you have a /boot parition, since some 
>ditros/administrator put a symbolic link "boot" to "." in /boot when it's 
>on 
>a partition by itself.
>
>  
>