* [gentoo-embedded] [embedded] first step in programming geode target
@ 2009-03-26 20:50 99% esa
0 siblings, 0 replies; 1+ results
From: esa @ 2009-03-26 20:50 UTC (permalink / raw
To: gentoo-embedded
Dear users,
It's my first step to program a embedded system.
It's a industrial PC with a compact flash. On this compact flash, I put
uclibc + busybox.
So, I think, it is not a cross-development.
Until now, I program on DOS system with a IDE like BORLAND CPP.
I think, it is not possible to use such IDE on linux under a terminal
session ( so without using X, KDE, Gnome ).
I read, that CODE::blocks is a good IDE.
My question :
- Do I install the GNOME, X Windows or KDE for using CODE::block ? What is
the best ?
- For my target, I use uclibc. Must I install code block under my CHOST (
where I install uclibc ). Or maybee it is not necessary.
- In this case, must I configure CODE::block to use uclibc ?
-Is it something important to configure in MAKE.CONF ?
- my target is a Industrial PC with a GEODE processor.
I know, it is a lot of questions
Is it a document, where I can find what I can use and how to configure ?
Thanks again for your help.
Regards
Eric
--
View this message in context: http://www.nabble.com/-embedded--first-step-in-programming-geode-target-tp22668975p22668975.html
Sent from the gentoo-embedded mailing list archive at Nabble.com.
^ permalink raw reply [relevance 99%]
Results 1-1 of 1 | reverse | options above
-- pct% links below jump to the message on this page, permalinks otherwise --
2009-03-26 20:50 99% [gentoo-embedded] [embedded] first step in programming geode target esa
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox