Linux version 2.4.19-gentoo-r1 (root@preston) (gcc version 2.95.3 20010315 (release)) #1 Thu May 2 19:47:45 BST 2002 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 00000000000a0000 (usable) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000001fff0000 (usable) BIOS-e820: 000000001fff0000 - 000000001fff3000 (ACPI NVS) BIOS-e820: 000000001fff3000 - 0000000020000000 (ACPI data) BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved) 511MB LOWMEM available. On node 0 totalpages: 131056 zone(0): 4096 pages. zone(1): 126960 pages. zone(2): 0 pages. Kernel command line: auto BOOT_IMAGE=NewerKernel root=7201 devfs=mount Local APIC disabled by BIOS -- reenabling. Found and enabled local APIC! Initializing CPU#0 Detected 1400.365 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 2744.48 BogoMIPS Memory: 514688k/524224k available (1516k kernel code, 9152k reserved, 412k data, 264k init, 0k highmem) Dentry cache hash table entries: 65536 (order: 7, 524288 bytes) Inode cache hash table entries: 32768 (order: 6, 262144 bytes) Mount cache hash table entries: 8192 (order: 4, 65536 bytes) Buffer cache hash table entries: 32768 (order: 5, 131072 bytes) Page-cache hash table entries: 131072 (order: 7, 524288 bytes) CPU: Before vendor init, caps: 0183fbff c1c7fbff 00000000, vendor = 2 CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line) CPU: L2 Cache: 256K (64 bytes/line) CPU: After vendor init, caps: 0183fbff c1c7fbff 00000000 00000000 Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: After generic, caps: 0183fbff c1c7fbff 00000000 00000000 CPU: Common caps: 0183fbff c1c7fbff 00000000 00000000 CPU: AMD Athlon(tm) processor stepping 04 Enabling fast FPU save and restore... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: Intel PCI: PCI BIOS revision 2.10 entry at 0xfb4e0, last bus=1 PCI: Using configuration type 1 PCI: Probing PCI hardware Disabling VIA memory write queue (PCI ID 0305, rev 02): [55] 89 & 1f -> 09 Unknown bridge resource 0: assuming transparent PCI: Using IRQ router VIA [1106/0686] at 00:07.0 PCI: Disabling Via external APIC routing isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found PnPBIOS: Found PnP BIOS installation structure at 0xc00fbff0 PnPBIOS: PnP BIOS version 1.0, entry 0xf0000:0xc020, dseg 0xf0000 PnPBIOS: 14 nodes reported by PnP BIOS; 14 recorded by driver Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket apm: BIOS version 1.2 Flags 0x07 (Driver version 1.16) Starting kswapd Journalled Block Device driver loaded devfs: v1.12 (20020219) Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x1 Installing knfsd (copyright (C) 1996 okir@monad.swb.de). Detected PS/2 Mouse Port. pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A Real Time Clock Driver v1.10e block: 992 slots per queue, batch=248 Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VP_IDE: IDE controller on PCI bus 00 dev 39 VP_IDE: chipset revision 16 VP_IDE: not 100% native mode: will probe irqs later ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VP_IDE: VIA vt82c686a (rev 22) IDE UDMA66 controller on pci00:07.1 ide0: BM-DMA at 0xc000-0xc007, BIOS settings: hda:pio, hdb:pio ide1: BM-DMA at 0xc008-0xc00f, BIOS settings: hdc:DMA, hdd:pio HPT370: IDE controller on PCI bus 00 dev 98 PCI: Found IRQ 11 for device 00:13.0 HPT370: chipset revision 3 HPT370: not 100% native mode: will probe irqs later HPT370: using 33MHz PCI clock ide2: BM-DMA at 0xe800-0xe807, BIOS settings: hde:DMA, hdf:DMA ide3: BM-DMA at 0xe808-0xe80f, BIOS settings: hdg:pio, hdh:pio hdc: CRD-8322B, ATAPI CD/DVD-ROM drive hde: IC35L020AVER07-0, ATA DISK drive hdf: IC35L020AVER07-0, ATA DISK drive ide1 at 0x170-0x177,0x376 on irq 15 ide2 at 0xd800-0xd807,0xdc02 on irq 11 hde: 40188960 sectors (20577 MB) w/1916KiB Cache, CHS=39870/16/63, UDMA(44) hdf: 40188960 sectors (20577 MB) w/1916KiB Cache, CHS=39870/16/63, UDMA(44) hdc: ATAPI 32X CD-ROM drive, 128kB Cache, DMA Uniform CD-ROM driver Revision: 3.12 Partition check: /dev/ide/host2/bus0/target0/lun0: [PTBL] [2501/255/63] p1 p2 /dev/ide/host2/bus0/target1/lun0: unknown partition table Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 ataraid/d0: p1 p2 Highpoint HPT370 Softwareraid driver for linux version 0.01 Drive 0 is 19623 Mb Drive 1 is 19623 Mb Raid array consists of 2 drives. usb.c: registered new driver usbdevfs usb.c: registered new driver hub NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 4096 buckets, 32Kbytes TCP: Hash tables configured (established 32768 bind 32768) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. FAT: bogus logical sector size 0 reiserfs: checking transaction log (device 72:01) ... Using r5 hash to sort names ReiserFS version 3.6.25 VFS: Mounted root (reiserfs filesystem) readonly. Mounted devfs on /dev Freeing unused kernel memory: 264k freed Adding Swap: 1044216k swap-space (priority -1) 8139too Fast Ethernet driver 0.9.24 PCI: Found IRQ 10 for device 00:0d.0 PCI: Sharing IRQ 10 with 00:0f.0 eth0: RealTek RTL8139 Fast Ethernet at 0xcc00, 00:d0:70:01:a2:e8, IRQ 10 eth0: Identified 8139 chip type 'RTL-8139C' usb-uhci.c: $Revision: 1.275 $ time 19:51:16 May 2 2002 usb-uhci.c: High bandwidth mode enabled PCI: Found IRQ 5 for device 00:07.2 PCI: Sharing IRQ 5 with 00:07.3 usb-uhci.c: USB UHCI at I/O 0xc400, IRQ 5 usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected PCI: Found IRQ 5 for device 00:07.3 PCI: Sharing IRQ 5 with 00:07.2 usb-uhci.c: USB UHCI at I/O 0xc800, IRQ 5 usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 2 hub.c: USB hub found hub.c: 2 ports detected usb-uhci.c: v1.275:USB Universal Host Controller Interface driver usb.c: registered new driver hid hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik hid-core.c: USB HID support drivers mice: PS/2 mouse device common for all mice hub.c: USB new device connect on bus1/2, assigned device number 2 devfs_register(1): could not append to parent, err: -17 devfs_register(a1): could not append to parent, err: -17 devfs_register(1): could not append to parent, err: -17 devfs_register(a1): could not append to parent, err: -17 devfs_register(1): could not append to parent, err: -17 devfs_register(a1): could not append to parent, err: -17 usb-uhci.c: interrupt, status 3, frame# 544 hiddev0: USB HID v1.00 Mouse [Microsoft Microsoft IntelliMouse® Optical] on usb1:2.0 eth0: Setting 100mbps full-duplex based on auto-negotiated partner ability 45e1. nvidia: loading NVIDIA NVdriver Kernel Module 1.0-2880 Tue Mar 26 08:12:38 PST 2002 Linux agpgart interface v0.99 (c) Jeff Hartmann agpgart: Maximum main memory to use for agp memory: 439M agpgart: Detected Via Apollo Pro KT133 chipset agpgart: AGP aperture is 64M @ 0xe8000000 NVRM: AGPGART: VIA Apollo KT133 chipset NVRM: AGPGART: aperture: 64M @ 0xe8000000 NVRM: AGPGART: aperture mapped from 0xe8000000 to 0xe1a9a000 NVRM: AGPGART: mode 4x NVRM: AGPGART: allocated 16 pages