* Re: [gentoo-alpha] alpha newbie question
@ 2006-03-02 13:29 99% ` Andrew Gaylard
0 siblings, 0 replies; 1+ results
From: Andrew Gaylard @ 2006-03-02 13:29 UTC (permalink / raw
To: gentoo-alpha
Nick Smith wrote:
>>>Surely, all the bootloader needs to know about is /boot?
>>>On my alpha I had no end of trouble trying to use XFS for /,
>>>until I realised that the bootloader only understood ext2.
>>>The solution was to make a separate ext2 partition for /boot,
>>>put the kernels there.
>>>
>>>
>>>
>>>
>well i just followed the handbook and created sda1 = swap and sda2 = ext3 = /
>
>does this mean im wasting my time on this very slloooow install and
>that its not even going to boot when im finished? or does the boot
>loader see ext3 as well?
>
>also i thought that it saw all my drives, but the bios ( or what alpha
>calls a bios ) see's all 3 9gig drives, but gentoo only see's sda,
>when i went looking in /dev/ it only has the nods for sda and sda1 and
>sda2 for some reason, i found a tips and tricks on the gentoo.org
>website on how to make raid nods, but that didnt seem to work for sdb
>and sdc. is this normal for alpha to only see the first drive? is
>there a way to make the nods to actually make use of the other drives
>in the system?
>
>
I don't know if the bootloader can boot off ext3 partitions; I've never
tried. You'll have to dig into the docs to find out.
To resolve SCSI problems, check if the kernel can see your devices by
looking at the output of "dmesg". If it shows all devices, then you're
nearly there. But if not, missing device nodes are the least of your
problems. And no, it is not normal for only the first drive to be seen;
I have two drives both of which have always shown up in dmesg.
So please post the relevant bits of dmesg output, including the SCSI
controller and all devices.
I'd try to partition your sdb and sdc, make filesystems on them, and
copy lots of data onto them to ensure that the hardware's behaving.
After all, this machine was probably built in the last millenium.
Only if that works would I try to get RAID working (and I'd try just
striping or mirroring sdb and sdc on their own first, before attempting
the / filesystem).
Andrew.
--
gentoo-alpha@gentoo.org mailing list
^ permalink raw reply [relevance 99%]
Results 1-1 of 1 | reverse | options above
-- pct% links below jump to the message on this page, permalinks otherwise --
2006-03-02 3:33 [gentoo-alpha] alpha newbie question Nick Smith
2006-03-02 10:03 ` kloeri
2006-03-02 10:40 ` Andrew Gaylard
2006-03-02 11:41 ` Ben de Luca
2006-03-02 12:31 ` Nick Smith
2006-03-02 13:29 99% ` Andrew Gaylard
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox